__________________
                _________-----|                  |-----_________
     -----------_________-----|  GOLD BOX PLANS  |-----_________-----------
                         -----|__________________|-----

Gen-2600

 MATERIALS:  (2) 10k OHM resistors
             (3) 1.4k OHM resistors
             (2) 2N3904 transistors
             (2) Photocells
             (2) LED's (Make sure they're real bright)
             Box to contain it in that will not allow sunlight in it.
             Some wire (Red and green for easiness sake)

 PROCEDURE

    Light from the LED's must shine directly on the photocells.  You may have
to have the LED touching the photocell for it to work.

 [ Schematic ]
                     +-----Photocell #1------+
                     |     +---I[---+        |
                     |     |   +-   |        |
                     |     |  Led#1 |        |
                     |  +--+        |        |Base
                     |  |  +--------+      *****
                     |  |  |             Transistor
                     |  |  |               *****
          Red #1-----+--+  +----------------+ |
                        |  |                  |Collector
                    +---+  |                  |
                    |    +-+                  +-----+------Green #2
                    |    | |                        |
                    |  +-+ |                        +-----------+
                    |  |   |                                    |
                    |  |   +---/\/----/\/----/\/----/\/---------+
                    |  |       10k    10k    1.4k   1.4k
                    |  |            R E S I S T O R S
                    |  |
                    |  +------------------+
                    +-------------------+ |
                                        | |
                                        + I[ LED #2
                                  +-----Photocell #2----+
                             Base |                     |
                                *****            +------+
                              Transistor         |
                                *****            |
                       Collector | | Emitter     |
                                 | +-------------+---Red #2
                        Green #1-+ |
                                 | +---+
                                 |     |
                                 +-/\/-+
                                   1.4k
                                 Resistor

    The 1.4k resistor is variable and if the second part of of the box is
skipped the box will still work but if someone picks up the fone they may
report it to the Phone Co.  The 1.4k will give you good reception with little
risk of the Gestapo knocking at your door.

    Take two green wires and strip the ends.  Twist one end of each together
so they make one wire.  Connect it to Green #1.  Label this 'Line #1'.  Do the
same but with red wire and attach it to Red #1.  Repeat the process for Red #2
and Green #2 and label it 'Line #2'.

 INSTALLATION

    Find two fone lines that are close together.  Label one of them 'Line #1'.
Cut the phone lines and take off the outer covering.  You'll see 4 colored
wires inside.  Cut the yellow and black wire off and strip the red and green
wires on both lines.
    Line #1 should be in two pieces.  Take the green wire of one end and con-
nect to one of the green wires on the box.  Take the other half of the fone
line green wire and connect it to the other green wires on the gold box.  Do
the same for the red wires on the other line and the red wires on the box.
    Now, find out what number you hooked up the gold box to.  Go home and call
it.  You should get a dial tone and you can dial out.  If not, re-check every-
thing.  If it still doesn't work, pack up and go home.

Disclaimer: The file contained in the box above or displayed in a separate window from a link in the box above is NOT owned nor implied to be owned by BeYoND THe iLLuSioN. Most files at BeYoND THe iLLuSioN are originally from public Bulletin Board Systems (BBS) which were popular in the days before the Internet or from gopher, web, and FTP sites from the early days of the Internet which no longer exist today. Essentially, all files were acquired from the public domain in one for or another.

However, there have been occasions when copyright protected material has appeared on BeYoND THe iLLuSIoN without permission of the copyright holder. In these instances, we have and will continue to remove the copyright protected file as soon as it is brought to our attention. This can now be done using our Report Copyright Material form. Fill out the form, and the webmaster will be notified of the situation.

There are also times when files found on BeYoND THe iLLuSioN have a real home somewhere else on the Internet. In these instances, we will gladly replace the file with a link to its true home whenever it is brought to our attention. If you know of the true home of any of these files, you can use our Report Original URL form to bring it yo our attention.